AVerMedia Technologies 500 - Manual (Page 33)

30
Chapter 4
Troubleshooting
This chapter provides many useful tips on how to solve common problems while
using the AVerKey500 Pro.
There is no picture on my TV.
1. Check all the connectors again as shown in this manual.
2. Check your TV remote control on/off switch and channel setting.
3. Verify the setting of Composite Input or S-VHS Input of your TV set.
4. If you are using a SCART connector, check the SCART input of your TV set.
5. If you are using a notebook, you may have to switch to external VGA mode.
(Refer to your notebook's manual.)
6. As specified by IBM, some systems may require that the monitor is present and
connected when the system is powered up.
The picture on my TV is distorted.
1. Before doing any adjustments, reset all the picture attributes to the factory
default setting using the RESET button on the remote control.
2. Each VIDEO display device is slightly different from another. Use the Panning
Control of AVerKey500 Pro to adjust the picture.
3. Use the Brightness and Sharpness picture attributes controls on the remote
control to reduce the distortion.