Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 40)

B-4 OPERATION B-4
LASER POINTER
Laser pointer is used to aid in guiding the TANDEM
CRUISER™ . The laser pointer mounts to the nozzle or
nozzle extensions. Align the wire in the joint, then posi-
tion the laser pointer approximately 3” (76mm) in front
of the wire, also pointing into the joint.
Turn the laser off when not welding.
TOUCH SENSE
ELECTRIC SHOCK can kill.
• If the Touch Sense is enabled, the
Power Source output is ON as long
as the Feed Forward button is held.
Avoid touching any portion of the
weld circuit while feeding.
------------------------------------------------------------------------
The touch sense option, when enabled, allows the
operator to feed the wire forward until it touches the
workpiece. When contact to the work is made, the wire
will stop.
If the touch sense option is disabled, the wire is “cold”
during the Feed Forward time. It will not stop when it
touches the work.
(See P.15 in the Set-Up Features Menu, this
Section)
POWER-UP SEQUENCE
When power is first applied to the TANDEM
CRUISER™ the MODE SELECT Display reads “ TAN-
DEM CRUISER™ Initializing...”. Once the Power
Wave AC/DC has initialized (20 to 60 seconds) a
“lamp test” is performed.
• All discrete LED’s, seven segment displays and
alpha numeric displays will be turned ON for 2 sec-
onds.
• After 2 seconds all displays are turned OFF again
and the MSP Display will show:
After initialization is complete, the MSP Display will
show the weld mode. The upper displays will show the
parameters that were selected when the machine was
last powered down and the WELD MODE Indicator will
be ON.
TANDEM CRUISER™
• Class II laser radiation present. Do not stare
into laser beam or view directly with optical
instruments.
------------------------------------------------------------------------
CAUTION
FIGURE B.6 - MSP DISPLAY
FIGURE B.7 - WELD MODE INDICATOR
WARNING