Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 18)

A-11 INSTALLATION
TANDEM CRUISER™
A-11
CROSS SLIDE AND WIRE DRIVE
Each slide has 4” (102mm) of travel.
When assembling the Cruiser, verify that no compo-
nents at electrode potential contact the frame through-
out the entire travel distance of the slides.
The slides may be disassembled and then the position
adjusted relative to each other. Do not attach other
devices to the wire drive and cross slide assembly.
Instead, mount accessories to the tube and clamp
frame work.
When shipped from the factory, the wire drives are
mounted using the outer set of bracket slots. Each
wire drive has an inner set of bracket slots for spacing
the wire drives closer together.
Assemble the Spacer Blocks and Nozzle Extension as
required to adjust the lead arc stick-out relative to the
trail arc stick-out.
FIGURE A.13 FACTORY POSITION