Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 13)

Clamps
• Tighten clamp bolts to 25 ft-lbs (34 Nm).
• Use clamps with a key on horizontal tubes.
Collars
• Tighten collar screw to 42 in-lbs (0.3 Nm)
Lift Bail
• Tighten lift bail hardware to 24 in-lbs (0.17 Nm). Do
not overtighten or the mast may become distorted.
Chain and Mast Anchor
• The chain must be connected from the base to the
mast before lifting.
• Tighten all hardware as shown.
A-6 INSTALLATION
TANDEM CRUISER™
A-6
OUTRIGGERS
The outriggers “steer” the TANDEM CRUISER™ along
a vertical surface by driving it at a slight angle.
Suggested offset between the front and rear outriggers
is 1/2” (12.7mm). Larger offsets increase the friction
driving the
TANDEM CRUISER™ forward and may
cause travel motor overcurrent errors and rapid wheel
wear.
When assembling the TANDEM CRUISER™ , adjust
the cross slide to the middle position and position the
wire in the joint. Then assemble the front and rear out-
riggers, and make fine adjustments to the wire position
using the cross slide.
The outriggers may be stacked to gain extra length.
Slide a T Nut (S28835) into the extrusion and then
insert a 1/4-20 bolt through the outrigger slots.
FIGURE A.5 - OUTRIGGERS
Clutch
FIGURE A.6 - OUTRIGGERS EXTENSION
FIGURE A.1b - CLAMPS
FIGURE A.2 - COLLARS
FIGURE A.3 - LIFT BALE
FIGURE A.4 - CHAIN AND MAST ANCHOR