Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 17)

A-10 INSTALLATION
TANDEM CRUISER™
A-10
LEVELING THE WHEELS
The frame mounting holes for bolting the front wheels
are oversized to allow for leveling of the front wheels.
To level the wheels: (See Figure A.12a)
1. Turn off power at the welding power
source.
2. Place the tractor on a stable and level surface.
3. Determine the axis that the tractor pivots.
4. While keeping both rear wheels in contact with
the surface, loosen the 4 front bolts securing
wheel “A” and reposition the wheel lower to
contact the surface, and then tighten the bolts to
10 ft-lbs (13.6 N-m) (See Figure A.12b)
5. If more adjustment is required, loosen the 4
front bolts securing wheel “B” and reposition
to allow both front wheels and both rear wheels
to contact the surface at the same time. Tighten
the bolts to 10 ft-lbs (13.6 N-m)
WARNING
FIGURE A.12a
FIGURE A.12b