Lincoln Electric IM10114 TANDEM CRUISER - Manual (Page 12)

A-5 INSTALLATION
TANDEM CRUISER™
A-5
GENERAL ASSEMBLY
ELECTRIC SHOCK can kill.
• Improperly secured clamps
and collars may shift, causing
parts at electrode potential to
contact the tractor frame or
other components.
• Only qualified personnel
should install, use or service
this equipment.
------------------------------------------------------------------------
WARNING
FALLING EQUIPMENT can cause
injury.
• Lift only with equipment of
adequate capacity
• Be sure the machine is stable
when lifting.
• Do not lift the machine if the lift bail is damaged.
• Do not operate machine while suspended from
lift bail.
• Failure to properly secure the clamps, collars,
chains and lift bail may result in physical injury.
------------------------------------------------------------------------
WARNING
FIGURE A.1 - BUTT JOINT GUIDE
FIGURE A.1a - BUTT JOINT GUIDE
Loosen bolts
Slide and remove the butt joint kit
REMOVING THE BUTT JOINT GUIDE
1. Loosen the bolts on the clamp as shown. Slide and
remove the butt joint guide kit.
2. Loosen the pendant clamp bolts. Slide the tube
supporting the pendant and flux hopper until it is
flush with the end of the clamp. Tighten all the
clamp bolts to 25 ft-lb.