beautypg.com

Installation, Bracket gasket enclosure back hardware – Lincoln Electric IM10098 CRUISER User Manual

Page 14

background image

A-7

INSTALLATION

CRUISER

A-7

WIRE REEL ENCLOSURE ASSEMBLY

1.

Determine the angular orientation of the wire reel
enclosure relative to the spindle clamp. To change
the angle of the enclosure, remove the 6 bolts
securing the enclosure back to the mounting brack-
et using a 7/16” wrench. Reassemble at the desire
angle, keep the gasket centered relative to the
enclosure back. Provisions are made to rotate the
enclosure in 30° increments.

2.

Unscrew the spindle brake and remove the spindle
brake parts and the spindle.

3.

Remove two of the bolts from the spindle assem-
bly using a 1/4” hex key. Assemble the enclosure
back to the spindle assembly and tighten the bolts.

FIGURE A.11a - ENCLOSURE ASSEMBLY

FIGURE A.11b - ENCLUSURE MOUNTING

BRACKET

GASKET

ENCLOSURE
BACK

HARDWARE