IEI Integration AUPS-C20 v1.02 - Manual (Page 47)

AUPS-C20 UPS Module
Page 39
DANGER!
1. Disassemble and Reconstruction
“Do not disassemble or reconstruct battery”
The battery pack has safety function and protection circuit to avoid the danger. If they have
serious damage, it will cause the generating heat, smoke, rupture or flame.
2. Short-circuit
“Do not short-circuit battery”
Do not connect the + and – terminals with metals (such as wire). Do not carry or store the
battery with metal objects (such as wire, necklace or hairpins). If the battery is short-circuited,
excessive large current will flow and then the generating heat, smoke, rupture of flame will
occur. And also, it causes generating heat at metals.
3. Incineration and Heating
“Do not incinerate or heat the battery”
These occur the melting of insulator, damage of gas release vent or safety function, or ignition
on electrolyte. Above mentioned matters cause the generating heat, smoke, rupture or flame.
4. Use Nearby Heated Place
“Do not use or leave battery nearby the fire, stove or heated place (more than 80 ℃ )”
In case that separator made of polymer is melted by high temperature, the internal short-circuit
occurs in individual cells and then it causes the generating heat, smoke, rupture or flame. In
addition, do not use the battery under the heated place (more than 80℃) for same reason.
5. Immersion
“Do not immerse the battery in water or sea water, or get it wet”
If the protection circuit included in the battery is broken, the battery will be charged at extreme
current or voltage and the abnormal chemical reaction occurs in it. And then it causes the
generating heat, smoke, rupture or flame.
6. Charge Nearby Heated Place
“Do not charge battery nearby the fire or under the blazing sun”
If the protection circuit to avoid the danger works under high temperature or it is broken, the
battery will be charged at abnormal current (or voltage) and abnormal chemical reaction will
occur. It caused the generating heat, smoke, rupture or flame.
7. Charger and Charge Condition
“Do use the specified charger and observe charging requirement”
If the battery is charged with unspecified condition (under high temperature over the regulated
value, excessive high voltage or current over regulated value, or remodeled charger), there