IEI Integration AUPS UART Protocal SPC - Manual (Page 5)

AUPS IEI Technology Corp.
- 5 -
Command List
You can use following pre-defined commands un the application to communicate with
MCU and to receive data returned from MCU.
Command List:
Command Description Return bytes
0x01 Select Smart Battery A None
0x02 Select Smart Battery B None
0x22 Read Smart Battery Type ( LION: 4C and NIMH: 4E ) 1 byte
0x09 Read Smart Battery Output Voltage ( mV ) 2byte
0x0A Read Smart Battery Electric Current ( mA ) 2byte
0x08 Read Smart Battery Internal Temperature ( ºC ) 2byte
0x0F Read Smart Battery Capacity ( % ) 2byte
0x11 Read Smart Battery Discharging Time ( Minute ) 2byte
0x40 Read Smart Battery Status 1 2byte
0x41 Read Smart Battery Status 2 2byte
0x42 Read MCU Firmware Version 1byte
0x43 Enable Buzzer None
0x44 Disable Buzzer None
0x45 Turn On UPS Output None
0x46 Turn Off UPS Output None
0x47 Enable LAN None
0x48 Disable LAN None
0x50 Read IP Address 4byte
0x51 Write IP Address 4byte
0x52 Read Gateway 4byte
0x53 Write Gateway 4byte
0x54 Read Primary DNS 4byte
0x55 Write Primary DNS 4byte
0x56 Read Secondary DNS 4byte
0x57 Write Secondary DNS 4 bytes