IEI Integration EP-308A v1.15 - Manual (Page 71)

EP-308A/EP-308AS POS
Page 61
ƒ Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Î
Disabled D EFAULT
Remote access is disabled.
Î
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
These configuration options are discussed below.
ƒ Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
Î
COM1 D EFAULT
System is remotely accessed through COM1
Î
COM2 System is remotely accessed through COM2
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
ƒ Base Address, IRQ [2F8h,3]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
ƒ Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available