IEI Integration AFL2-W07A-N26 - Manual (Page 75)

AFL2-W07A-N26
P a g e 59
6.3 Tu rn o ff th e P o we r
WARNING:
Failing to turn off the system before opening it can cause permanent
damage to the system and serious or fatal injury to the user.
Before any maintenance procedures are carried out on the system, make sure the system
is turned off.
To power off the system, follow the steps below:
S te p 1: Locate the Function and Brightness Up function keys. See Section 1.2.1.1.
S te p 2: Hold down the Function and Brightness Up buttons for six seconds to power off
the system. S te p 0:
6.4 Op e n in g th e S ys te m
6.4.1 Re m o vin g th e Ba c k Co ve r
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL2-W07A-N26 internally the back cover must be removed. To remove the
back cover, please follow the steps below.
S te p 1: Follow all anti-static procedures. See Section 6.2.
S te p 2: Turn off the power. See Section 6.3.
S te p 3: Remove a total of ten (10) retention screws from the back cover (Figure 6-1).