3 installation and configuration steps, 4 msata card installation, Nstallation and – IEI Integration AFL2-W07A-N26 User Manual

Page 39: Onfiguration, Teps, Sata, Card, Nstallation, 4 m s ata c a rd in s ta lla tio n

AFL2-W07A-N26

P a g e 23

 Anti-static Discharge: If a user open the rear panel of the flat bezel panel PC,

to configure the jumpers or plug in added peripheral devices, ground

themselves first and wear and anti-static wristband.

4.3 In s ta lla tio n a n d Co n fig u ra tio n S te ps

The following installation steps must be followed.

S te p 1:

Unpack the flat bezel panel PC.

S te p 2:

Install the mSATA card.

S te p 3:

Configure the system.

S te p 4:

Connect peripheral devices to the flat bezel panel PC.

S te p 5:

Mount the flat bezel panel PC.

S te p 0:

4.4 m S ATA c a rd In s ta lla tio n

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To install the mSATA card into the AFL2-W07A-N26, please follow the steps below:

S te p 1:

Remove one (1) retention screw from the mSATA cover (Figure 4-1).