IEI Integration AFL2-W07A-N26 - Manual (Page 74)

AFL2-W07A-N26
P a g e 58
6.1 S ys te m Ma in te n a n c e In tro d u c tio n
If the components of the AFL2-W07A-N26 fail they must be replaced. Components that
can be replaced include:
 SO-DIMM module
 WLAN module
Please contact the system reseller or vendor to purchase the replacement parts. Back
cover removal instructions for the AFL2-W07A-N26 are described below.
6.2 An ti-s ta tic P re c a u tio n s
WARNING:
Failure to take ESD precautions during the maintenance of the
AFL2-W07A-N26 may result in permanent damage to the
AFL2-W07A-N26 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the AFL2-W07A-N26. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the AFL2-W07A-N26 is accessed internally, or any other
electrical component is handled, the following anti-static precautions are strictly adhered
to.
 Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
 Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
 Use an anti-static pad: - When configuring the AFL2-W07A-N26, place it on
an antic-static pad. This reduces the possibility of ESD damaging the
AFL2-W07A-N26.
 Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.