5 removing the back cover, Emoving the, Over – IEI Integration AFL-xxA-N270-Series v1.03 User Manual

Page 47: Figure 4-1: back cover retention screws

AFL-xxA-N270 Series Panel PC

Page 31

4.5 Removing the Back Cover

WARNING:

Over-tightening back cover screws will crack the plastic frame.

Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).

To access the AFL-xxA-N270 internally the back cover must be removed. To remove the

back cover, please follow the steps below.

Step 1:

Remove the retention screws (Figure 4-1) and lift the cover off the flat panel PC.

Figure 4-1: Back Cover Retention Screws

Step 2:

Lift the cover off and pull down the cover a bit to make it possible to lift the cover

further more after removing the retention screws (Figure 4-2). More strength is

required to separate the cover from the chassis.

Step 0:

Figure 4-2: AFL-xxA-N270 Plastic Back Cover Removal