White’s Electronics Spectra V3 - Manual (Page 47)

Complete Owner’s Guide - Spectra 47
®
When selecting a channel other than Channel 4, an ENABLE/CONNECT sequence is required -
Select Wireless Headphones and press ENTER.
1. Press ENTER to Enable “X” in box” (turn on) Wireless Headphone transmitter.
2. Press Wireless Headphone Power Button to turn ON Wireless Headphone.
3. If there is significant wireless channel interference, the built in speaker will occasionally sound. A different
Wireless channel should be considered. To avoid cross talk between additional V3 detectors with Spectrasound
headphones, set each to a different wireless channel.
4. Connect Sequence “AFTER CHANNEL CHANGE” – MENU/TAB to Connect, Press ENTER, Hold Power button
on Wireless Headphone, beep-BEEP, beep-BEEP, and display prompts indicates connection made, squeeze
and release trigger to search with wireless activated.
5. CHANNEL SELECTING a different wireless channel to overcome any local wireless interference.
• Arrow down to Channel, Select (arrow left & right) to find a Channel free of interference.
Color Bar indicates level of external interference for each channel choice. Green
representing clear channel, Red representing external interference. Ideally, select the
channel with the largest portion of green within the bar.
6. POWER LEVEL is provided to drive the headphone transmitter with enough power to overcome any reasonabl
distance or wireless signal resistance. Arrow down to Power Level, Select (arrow left & right) a power level
strong enough to provide quality sound. In-field operation at power levels less than 5 are not recommended;
7. When Monitor Battery Speaker is selected “X” interference in wireless data for any reason will cause the built-in
speaker to sound.
When Monitor Battery Speaker is not selected “empty box”, built-in speaker will never sound.
Plug-in headphones and wireless headphones (enabled) continue to operate normally.
Spectra V3 will also provide Wireless battery voltage -
• Press MENU twice, Arrow down to Expert and press ENTER.
• Arrow down to Information, press ENTER.
• Note Wireless Voltage, at least 2 + volts.
• Wireless will operate between 2 - 3+ volts. Under 2 volts
wireless performance becomes uncertain.
More on SpectraSound™ More on SpectraSound™
TROUBLESHOOTING -
Substandard wireless sound, or built-in Speaker beeps when
Wireless are used.
• Select a different wireless channel.
• Increase Wireless Power
• Turn OFF Monitor Speaker.
• Check Wireless Battery.
• See above voltage - replace as needed.
Channel
Power Level