WARN PullzAll SERVICE GUIDE 885005 & 885006 - Manual (Page 45)

987606A1.doc Page 45 of 46
1.3 Motor running but
not pulling
Damaged Geartrain
Replace PullzAll
1.4 Motor does not run.
Check Battery Condition
visually (any short circuit )
Check Battery condition
Faulty Trigger Switch
Defective Motor
Check Wiring condition
Repair or replace it with new
Repair or replace Switch
Replace Motor
1.6 Electrical sparks
appear around
Motor.
Loose connection of Wires to
Motor Terminals.
Replace Motor Assembly.
1.7 Wire harness
insulation has melted
Switch held in power in
position while PullzAll is
stalled.
Replace Wire harness or PullzAll
Motor Assembly.
Poor installation caused Wire
insulation to be rubbed off or
cut, causing direct short.
Replace Wire harness.
1.8 PullzAll makes
squeaking / high
pitch noise.
Drum Bushing not lubricated.
Grease Drum Bushings.
1.9 Full speed only, no
variable speed control
1.10 Malfunctioning
Ensure trigger is only
partially depressed
Not operating correctly.
Replace Variable Speed Trigger
switch
Cease operation. Diagnose,
Repair or Replace.
1.11 Rapid discharge of
Battery
Check for Power Switch Left
on during storage.
Check for Terminals
corrosion
Defects in charging system
such as faulty Regulator,
Always turn unit off when not in
use.
Clean and service
Check charging system