Etwork, Ettings, Basic network setting – WansView NCB546 User Manual
Page 13: Wifi setting, Adsl setting, Upnp setting, 2 network settings
http://www.wansview.com
12
3.2 Network Settings
3.2.1 Basic network setting
The user can also enter the Basic Network Settings to set the IP address except using
the search software. See below Figure 10.
Figure 10 Network settings
3.2.2 WIFI setting
Please refer to chapter 2.2.
3.2.3 ADSL setting
User could enable the ADSL Dialup according to the below Figure 11 (The ADSL
provider will assign the user name and password to you when you apply for ADSL
service.) Connect the device directly to the ADSL modem and it is connected to the
Internet.
Figure 11 ADSL setting
3.2.4 UPnP setting
UPnP means plug and play, if you enable UPnP, once the IP camera is connected into
the LAN, it will communicate with the router in the LAN and do the port-forwarding with
open port of router automatically. In figure 12, you only tick “Using UPnP to Map Port” to
finish the setting, you can check if the UPnP is successful in maintain interface.
Figure 12 UPnP settings
Before using the UPn
P function, please make sure the router‟s UPnP function has been