Hazard identification: explanation of signal words – Vestil VGP-100 User Manual

Page 2

rev. 2/15/2013

Product manual, operation instructions.doc

HAZARD IDENTIFICATION: explanation of signal words

This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable

seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention to
uses of the product likely cause property damage.

The signal words used appear below along with the meaning of each word:

Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme
situations.

Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.

Indicates a hazardous situation which, if not avoided, COULD result in MINOR or
MODERATE injury.

Identifies practices likely to result in product/property damage, such as operation that

might damage the product.

Each person who assembles, installs, uses, or maintains this product should read the entire manual and fully

understand the directions in advance. If after reading the manual you do not understand an instruction, ask
your supervisor or employer for clarification, because failure to adhere to the directions in this manual
might result in serious personal injury.

SAFETY GUIDELINES

Vestil diligently strives to identify foreseeable hazards associated with the use of its products. However, material

handling is inherently dangerous and no manual can address every conceivable risk. The end-user ultimately is
responsible for exercising sound judgment at all times.

Electrocution might result if any part of the product contacts electrified wires. Reduce the likelihood of

electrocution by applying common sense:


DO NOT contact electrified wires with any part of this device, your body, or clothing.



DO NOT use or store the product where contact with electrified wires is likely.



Always inspect the usage area before using the product & implement precautions that account for conditions.

If this product is used improperly or carelessly, the operator and/or bystanders might sustain serious

personal injuries or even be killed. To reduce the likelihood of injury:
 Failure to read and understand the entire manual before assembling, installing, using or servicing the
product is a misuse of the product.

 Read the manual to refresh your understanding of proper use and maintenance procedures.

 DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and certain that
it will be safe to use afterwards.

 DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. Unauthorized
modifications automatically void the Limited Warranty (see p. 6) and might make the lift unsafe to use.

 DO NOT exceed the maximum rated load (see Label 287 on product).

 Center pipes over the wheels/axle to properly balance loads on the hand truck.

 DO NOT use the hand truck on inclined surfaces. Keep pipes level during transport to prevent sliding.

 Inspect the product before each use.
A. DO NOT use this product if the inspection reveals structural damage. Examples of structural damage include,

but are not limited to, the following: 1) Cracked, broken or significantly deformed load-bearing members; 2)
cracked welds; 3) missing, or deformed safety chain/strap; 3) corrosion, severe wear, or other condition that
affects the ability of the product to support weight or itself. Replace each part that fails to pass an inspection,
and DO NOT use the product until it is fully restored to normal condition.

B. DO NOT use the product if any unusual noise or movement is observed. If a malfunction occurs, remove the

unit from service and notify your supervisor & maintenance personnel about the issue.

 DO NOT use this device UNLESS all product labels (see “Label Placement Diagram”) are readable and undamaged.

Proper use, maintenance, and storage are essential for this product to function properly.

o Always use this product in accordance with the instructions in this manual and consistent with any training relevant

to machines, devices, etc. used in conjunction with this product.
o Keep the product clean & dry. Lubricate moving parts.