Vestil SWA-48 - Manual

1
WARNINGS & SAFETY INSTRUCTIONS
Ensure that all employees understand and follow the following.
• Read and understand the owner's manual before using or
servicing the stretch-wrap machine.
• Ensure that all safety and warning labels stay in place and
that they are legible.
• Do not use the machine if any damage or unusual noise
is observed.
• Watch the pallet or container carefully when the turntable
is in motion, particularly in the case of any overhanging load.
• Rotating the palletized loads can become unstable. Be
prepared to stop the turntable in the even the load shifts.
• Make certain that the load is centered and stable before
operating the turntable.
• Warning: Keep all personnel clear of the machine when it
is in operation. Be certain no part of any person, fork truck,
or other object is in the path of the rotating load before
rotating the turntable.
• Warning: Do not stand or sit on the turntable or its load at
any time.
• Warning: Keep all body parts and clothing away from the
machine's drive system(s).
• Do not perform any modifications to the stretch-wrap
machine or its mast without the manufacturer's approval.
Failure to receive authorization for changes to the equipment
could void the warranty.
• Maintenance and repairs are to be done only by personnel
qualified to perform the required work. Consideration will
not be given for warranty repair labor charges without prior
written authorization by the manufacturer.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to shipment.
However, it is possible that the unit may incur damage during transit.
Inspect the unit closely when it arrives. If you see evidence of
SEMI-AUTOMATIC STRETCH WRAP MACHINE
MODEL SWA-48, POW-CAR
OWNER'S
MANUAL
Revised 0507 20-126-103
A company dedicated to solving ergonomic and material
handling problems since 1955.
SEMI-AUTOMATIC STRETCH WRAP MACHINE
MODEL SWA-48, POW-CAR
Contents
Installation Instructions .................................. 2-3
Routine Maintenance & Safety Chocks ............ 4
Belt Tensioning Procedure ............................... 5
Operation Instructions ...................................... 6
Exploded Turntable Parts Drawing & BOM ...... 7
Exploded Mast Parts Drawing & BOM ........... 8-9
SWA-48, POW-CAR Electrical Diagram ........ 10
Powered Mast Electrical Diagram .................. 11
Motor Speed Controller Parameters ............... 13
Troubleshooting ............................................. 13
Safety Label Identification .............................. 14
Warranty ......................................................... 15
VESTIL MANUFACTURING CORPORATION
2999 North Wayne St., Angola, IN 46703
Phone (260) 665-7586 • Fax (260) 665-1339
[email protected] • www.vestil.com
damage or rough handling to either the packaging or to the product
when it is being unloaded, immediately make a note of it on the Bill
of Lading!
It is important that you remove the product's packing upon its arrival
to ensure that there is no concealed damage or to enable a timely
claim with the carrier for freight damage.
Also, verify that the product and its specifications are as ordered.
WHEN ORDERING REPLACEMENT PARTS
We take pride in using quality parts on the equipment we
manufacture. We are not responsible for equipment problems
resulting from the use of unapproved replacement parts. To
order replacement or spare parts for this equipment, contact
the manufacturer.
In any communication with the manufacturer, please be
prepared to provide the machine's serial number, which is
indication of the machine dataplate.