Vestil LPRO - Manual

12/23/05
10/22/05
23-126-120.doc
V ESTIL M FG . C O . 1
V ESTIL M ANUFACTURING C ORP .
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: 260-665-1339
E-mail: [email protected] · Website: www.vestil.com
M
ODEL
H
PRO
-48-42-4 / L
PRO
-48-16-4
Serial number ____________
Assembly / Installation Instructions ………………..… 2
Masonry Instillation Guidelines ……………………….3
Warranty …………………………………….……..…. 4 Routine Maintenance and Safety Checks………………2
Safety Label Identification .............................................4
I MPORTANT N OTES , W ARNINGS AND S AFETY I NSTRUCTIONS
Ensure that all employees understand and follow the following.
* Failure to read and understand this owner’s manual before using or
servicing the high / low profile guards constitutes a misuse of the
product. All persons who will install or care for this product must be
familiar with this material.
o
Ensure that all safety labels stay in place and are legible.
o
Do not use the high / low profile guard if any damage is observed.
o The high / low profile guard is intended for use only on concrete surfaces of
sufficient strength and condition to be adequate for anchoring.
o
Contact the manufacturer for any needed MSDS information.
o
Do not perform any modifications to the high / low profile guard without
the manufacturer’s approval. Failure to receive authorization for
changes to the equipment could void the warranty.
o
Maintenance and repairs are to be done only by personnel qualified to
perform the required work. Consideration will not be given for warranty
repair charges without prior written authorization by the manufacturer.
WHEN ORDERING
REPLACEMENT PARTS :
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
R ECEIVING INSTRUCTIONS
It is possible that the unit
could incur damage during
transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
Also verify that the product
and its specifications are as
ordered.
O
WNER
’
S
M
ANUAL