Installation instructions – Vestil AHLT User Manual
Page 2
2
INSTALLATION INSTRUCTIONS
Review Complete Owner's Manual Before Commencing Installation.
For installation you will need the following:
1.)
A fork truck or hoisting means.
2.)
Lag bolts, masonry drill, masonry bit, wrench for lag bolt, grout, and steel shims.
Move the lift with straps or forks under frame.
Read all the warning labels on the lift and be sure all of the labels are on the lift.
Check local codes pertaining to your application.
If the power unit is to be mounted externally, be sure to blow out the connecting hydraulic line with
compressed air.
Be sure maintenance prop is in place before getting under platform.
After anchoring to floor, shim or grout the full length on the frame sides.
The entire length of the frame sides must be supported.
Operate lift through a few cycles. Check and add oil if necessary. See oil specification elsewhere
in this manual.
Clean up any debris or spilled oil.
- ABLT-H (7 pages)
- ABLT-H-LP (5 pages)
- ACH-60 (20 pages)
- ALL-T-2-GPT (10 pages)
- ALL-T-2 (9 pages)
- A-LIFT (12 pages)
- AIR-2000 (12 pages)
- AHA-KIT Come-Along kit (5 pages)
- AHA (25 pages)
- AF-xxxx (4 pages)
- APPL-1200-xx (1 page)
- ASP Series (5 pages)
- ATD (6 pages)
- ATP (9 pages)
- ATS (9 pages)
- BC series (12 pages)
- BOL-OR-40-BK (3 pages)
- BOL-SS-42-5.5 (5 pages)
- BOL-SSTOR-42-4.5 (5 pages)
- BT (20, 40, & 60) (12 pages)
- SELF SUPPORTING BRIDGE CRANE (9 pages)
- CART-DS-1000 (15 pages)
- CAN-A (1 page)
- CART-23 & -24, ALL MODELS (12 pages)
- CART-500-SCL (1 page)
- CART-550-SS (15 pages)
- CART-D-FR (18 pages)
- CART-S-FR (18 pages)
- CB-PMPS (13 pages)
- CBS Series (13 pages)
- CB-W-P (1 page)
- CB-W-S (1 page)
- CC-30-MC (59 pages)
- CH series (12 pages)
- COL-3-26-14 (5 pages)
- CYL-CK (1 page)
- CUP-3131 (4 pages)
- CPC (10 pages)
- CP Series (8 pages)
- COL-4-36-23 (5 pages)
- COL-3-26-44 (5 pages)
- COL-3-26-23 (5 pages)
- H series hoppers (13 pages)
- D-150 Dock Seals & Shelter Survey Sheet (1 page)