Vanguard Accu-Trans - Manual (Page 16)

Accu-Trans

Operating Procedures
12
Figure 5.0 Typical Test Report Printout
6.3.1 Transformer ID Entries:
The operator can enter test data using the
following procedures.
OPERATOR’S NOTE
Test Identification data are entered
with the keypad (item 2 of Figure 1.0).
The keypad has 10 keys that are alpha-
numerically marked, like pushbuttons
on a telephone. Keys are pressed for
each character position (marked by the
cursor) in the identification area; thus:
If, for example, we consider the key
marked 2/A B C, the first press of the
key selects the number “2,” pressing
the key a second time selects the letter
“A,” pressing the key a third time
selects the letter “B, and pressing the
key a fourth time selects the letter “C.”
Further pressing of the key returns to
the number selection; the cycle repeats
as the key continues to be pressed. The
characters selected are entered at the
position of the cursor. Pressing the up
key (
∧
) advances the cursor by one
space; pressing the down key (
∨
)
moves the cursor back one space. If a
character is erroneously entered, select
the new key to get the correct entry.
The first Identification (ID) display is the
COMPANY screen, which is shown below:
a) Enter the characters of the utility
company’s name. When this is done, press
COMPANY: