Vanguard Accu-Trans - Manual (Page 11)

Accu-Trans

Operating Procedures
7
4.0 PRETEST SETUP
4.1
Operating Voltages
The Accu-Trans operating voltages are
selectable between 90-130Vac, 50/60Hz or
200-240, 50/60Hz. Voltage selection is set
by the placement of jumpers on the power
terminal block as listed in Table 2.0 below
and Figures 2.0 and 3.0
.
Table 2.0 Voltage Selection
VOLTAGE SELECTION TERMINAL BLOCK JUMPERS
90-130Vac Brown to Blue & Yellow to Green
200-240Vac Blue to Yellow
Figure 2.0 90 to 130Vac Jumper Setting
Figure 3.0 210 to 240Vac Jumper Setting
120Vac Jumper Installation
220Vac Jumper Installation