Teledyne LeCroy QPHY-SAS2 - Manual (Page 17)

QPHY-SAS2 Software Option
917718 Rev A
17
7. Using the Find Device selection under the Tools menu, you will get the dialog below. Set it for T1 and
click on “Find device”.
Figure 9 - Device Identifier
8. This warning message appears. Select the “Yes” option. He resulting operation can take up to 30
seconds.
Figure 10 - Warning Message
If the search for device succeeds, the resulting dialog will look like this with the SAS Address shown in the
upper left.
Note: If you have a different cable adapter and are uncertain which SATA cable is the primary port, try both and the primary port will
have an address exactly one less than the secondary port.