Teledyne LeCroy MIPI D-PHY - Manual (Page 7)

Operator's Manual
918800 RevA 7
Eye Diagram Control Area
The Eye Diagram Control Area of the MIPI D-PHY dialog contains Show Eye, Eye Source, Bit Rate, and Find Bit
Rate fields.
After selecting your Mode, and configuring signals for Dp (Data Positive), Dn (Data Negative), CLKp (Clock
Positive), and CLKn (Clock Negative) as desired, make use of the following Eye Diagram Controls. MIPI D-PHY
processes the information and responds as the controls are used.
Show Eye
Marking this checkbox shows the eye diagram trace on the display area and includes a corresponding trace
descriptor label.
Eye Source
With HS High Speed Mode (LP Mode disables the Eye Diagram Control Area) selected and inputs selected as
indicated in the Mode and Input Selection Area of the MIPI D-PHY Dialog (on page 6) topic, use the Eye Source
field to select the HS signal (Dp (Data Positive), Dn (Data Negative), CLKp (Clock Positive), and CLKn (Clock
Negative)) for use on your Eye Diagram.
Additional choices for your Eye Diagram include Ddiff (Differential Data) and CLKdiff (Differential Clock).