Teledyne LeCroy MIPI D-PHY - Manual (Page 4)

MIPI D-PHY
4 918800 RevA
MIPI D-PHY Overview
The MIPI D-PHY debug utility provides MIPI D-PHY developers a way to perform typical compliance
measurements without being constrained by QualiPHY compliance parameters. This debug utility is used
alongside all the powerful oscilloscope features provided in LeCroy oscilloscopes to further analyze compliance
failures. Potential debug setup examples include:
 Setting up tests to run on much more acquisitions than the QualiPHY compliance software permits.
 Easily testing to compliance limits using LeCroy’s Pass/Fail testing and Tracks, Trends, and Histograms -
which can be created from any measured parameter.
 When combined with the MIPI D-PHY, CSI and DSI Serial Decoders, the oscilloscope becomes the ultimate
MIPI D-PHY debugging machine.
The Main MIPI D-PHY Dialog
Access the MIPI D-PHY software option from Analysis → MIPI D-PHY on the menu bar.
The main MIPI D-PHY dialog is shown.
MIPI D-PHY Dialog Details
Use the following sections to work through areas of the main dialog.
Enable, Show Decode, Setup Acquisition
Enable
Marking the Enable checkbox enables the controls on the dialog.
Notice how MIPI D-PHY provides its own, unique table and set of test parameters.