Teledyne LeCroy SENT Decoder - Manual (Page 9)

Instruction Manual
922664 Rev A 7
Verify Bit-Level Decode
When all Basic dialog values are set, you should already see a basic bit-level decoding on the selected
source trace. The Data Mode is set to bits by default, so that the remaining protocol-specific settings do
not matter for the initial bit-level decode.
In a correct bit-level decoding, bit transitions are all aligned with signal transitions, and the logical
interpretation of the bits is consistent with the physical level.
Review your decoded waveform for instances of incorrect bit-level decoding, particularly:

Decoding at an exact multiple of the Bit Rate that would not allow further interpretation of the
words

Bits not aligned with the transitions

Bit stream with gaps between the bits
Enable/Disable Decoder
Once preset, the four decoders can be enabled simultaneously or separately as often as you wish,
although this number may be limited depending on the type of source channels selected. Preset
decoders can be easily disabled without disrupting the configuration.
To enable:
Press the Front Panel Serial Decode button, or choose Analysis > Serial Decode, to open the Serial
Decode dialog, then check Decode On next to the respective decoder.
If View Decode is checked (default) on the Decode Setup dialog, a result table and decoded waveform
appears for each enabled decoder. The number of rows of data displayed on each table will depend on
the Table#Rows setting. The default is one, which can be increased, but doing so will decrease the
amount of the screen available to display traces.
To disable:
Deselect the Decode On box individually, or touch Turn All Off.