Teledyne LeCroy ST Automated Test Suite User Manual - Manual (Page 9)

9
2.3 Test Monitoring Console
The Test Monitoring Console (Figure 2-5) lists the tests that have been selected for execution, their
results, and their descriptions.
Figure 2-5
After adding a test (using the Add button in the Workspace Area), the test appears in the
Test Monitoring Console.
The Result column displays the test status upon completion. The Result field may display Passed,
Failed, or Done.
• When the test passes, Pass is shown in the Result field on a green background.
• When the test fails, Fail is shown in the Result field on a red background.
• When the test executes and the verification process is unable to confirm the expected behavior,
Done is shown in the Result field on a gray background (rarely occurs).
• When the test is unable to capture a valid trace file, the software displays a message:
“Error during recording; No trace file created”.
If the test fails, the verification software shows an error code in the Description field.
Buttons
The green Run all button, at the left, starts execution in sequential order of all tests in the monitoring
window.
The black Stop button, second from left, allows you to stop execution of the current test run.
The Run Failed Test Case(s) button, third from left, runs the failed test cases again.
The Run Selected Test Case(s) button, fourth from left, runs the selected test cases. You can select
multiple rows using CTRL+Right-Click.
The Remove Selected Test Case(s) button, fifth form left, deletes the selected tests from the list of
potential running tests. You can select multiple rows using CTRL+Right-Click.