Teledyne LeCroy PCI Express 2.0 Multi-Lead Probe - Manual (Page 4)

Trademarks and Servicemarks
Teledyne LeCroy, PETracer and Summit are trademarks of
Teledyne LeCroy.
All other trademarks are property of their respective
companies.
Changes
Product specifications are subject to change without notice.
Teledyne LeCroy reserves the right to revise the information
in this document without notice or penalty.
Teledyne LeCroy Customer Support
Online Download
Periodically check the Teledyne LeCroy Protocol Solutions
Group web site for software updates and other support
related to this product. Software updates are available to
users with a current Maintenance Agreement.
Mail: 3385 Scott Blvd., Santa Clara, CA 95054-3115
Web: teledynelecroy.com/Support/SoftwareDownload/
E-mail: [email protected]
Tel:
(800) 909-7112 (USA and Canada)
Tel: (408) 653-1260 (worldwide)
Fax: (408) 727-6622 (worldwide)
Copyright
© 2013 Teledyne LeCroy, Inc . All rights reserved. Part Number: 923767-00 Rev. A
This document may be printed and reproduced without additional permission, but all copies should contain this copyright
notice.
Recording Traffic
After you have set up the hardware and software, you can record traffic.
For instructions on setting up and implementing a recording, please refer to the Summit PCI Express Multi-Lane Protocol
Analyzer User Manual.
5
4. In the Link section (on the right), select the appropriate link width (x4 uses one probe pod, x8 uses two probe pods and
x16 uses four probe pods (see section 3 above).
5. At the bottom of the Link section, select Swizzling Config to display the Swizzling Config dialog.
You can drag and drop lane numbers to change lane order and match the actual connection.
6. Make sure Master Lane is dragged to an appropriate location. The Master Lane is the location of Lane 0. If you do not
know the location of Lane 0 any other active lane will work.
Auto-Configure lane swizzle
is supported by Summit
T3-16, T3-8 and T28.
For Summit T24 only Manual
Swizzle option is available.
Master Lane