beautypg.com

Safety compliance – Teledyne LeCroy AP031 User Manual

Page 15

background image

Operator’s Manual

923064-00 Rev A

13

Safety Compliance

EC Declaration of Conformity

– Low Voltage

The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:

EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control,
and laboratory use – Part 1: General requirements

EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 2-030: Particular requirements for testing and measuring
circuits

EN 61010-031/A1:2008 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 031: Safety requirements for hand-held probe assemblies
for electrical measurement and test.

Measurement Category III (CAT III), for measurements performed in the building
installation.

Measurement Category II (CAT II), for measurements performed on circuits directly
connected to the low-voltage installation.

Pollution Degree 2, operating environment where normally only dry non-
conductive pollution occurs. Conductivity caused by temporary condensation
should be expected.