Autostart AS-2775 User Manual
Page 28
P. 28 Installation
Guide
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2.
With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3.
Within 20 sec. of engaging the parking
brake, press and hold
LOCK
,
UNLOCK
or
START
on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
a.
LOCK
to lock the doors and shut down the engine;
b.
UNLOCK
to unlock the doors and shut down the engine;
c.
START
to shut down the engine without affecting the doors.
Note: The vehicle will also enter Ready Mode once the engine run time expires.
Bypass
Remote starters of this series offer three possibilities for bypass D2D: they are compatible with
Xpresskit, ADS and Fortin bypasses (Xpresskit by default).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same Remote Car Starter
model, to control both systems with a single remote control. To control the second vehicle,
simultaneously press the
TRUNK
button and the button of the function you wish to use.
Note: The remote control must be configured for second car operation by the installer.
Press
TRUNK
+
LOCK
buttons simultaneously: ....
LOCK
Press
TRUNK
+
UNLOCK
simultaneously: ..............
UNLOCK
Press
TRUNK
+
START
simultaneously: .................
START
Press
TRUNK
+
STOP
simultaneously: ...................
STOP
Press
TRUNK
+
START
simultaneously for 3 sec: ..
Cold Weather Mode
Horn Honk Timing
Follow these steps to program horn confirmation:
1. Enter programming mode (see on page 15)
⎯ the parking lights will stay on for up to 20
seconds.
2. Press and hold the brake pedal, then simultaneously press the
UNLOCK
and
START
buttons
⎯
the horn will chirp 5 times.
3. Release the brake pedal.
4. To change the timing:
a. To increase the Horn pulse by 3 ms, press the
LOCK
button.
b. To decrease the pulse by 3 ms, press the
UNLOCK
button.
c. To increase the pulse by 10 ms, press the
START
button.
d. To decrease the pulse by 10 ms, press the
TRUNK
button.