Autostart AS-2775 User Manual

Page 27

Installation Guide

P. 27

transmitter, and to unlock the other doors, if desired, by pressing the

UNLOCK

button for a second

time.
The output will provide a 1-second negative output when the

UNLOCK

button is pressed a second

time on the transmitter. This can be used not only as priority door access, but also as trunk
release.

Horn Confirmation:

AUX 1

can be programmed to trigger the horn every time the

LOCK

button is pressed, or when the

LOCK

button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is

enabled. If horn confirmation is disabled, panic mode will not be available.

The AUX 2 Timed Output

This 500 mA negative

AUX 2

output can be used for many different applications. It can be

programmed for priority door access if

AUX 1

is programmed for horn confirmation. For additional

information, please refer to the “3-pin Harness” section earlier in this Guide.

The AUX 3 / Trunk or Sunroof Output

This 500 mA negative

AUX 3

output can be used for many different applications. The output can be

programmed to give a 1-second pulse when the

TRUNK

button is pressed (if the ignition is

OFF

during a remote start), or to give a continuous output as long as the

TRUNK

button is held down (for

sunroof or window control).
If the Option 3 is selected, a disarm pulse will be sent before the trunk is popped. An arm pulse will
be sent 4 seconds later. This option is overridden when the Zone 3 option is used as a trunk pin
(Menu 3, Feature 5, Option 1).

Programmable External Trigger

For additional information, please refer to the “12-pin Accessories Harness” section earlier in this
Guide.

OEM-Style Alarm

The OEM-style alarm (if configured) monitors the doors, hood and ignition switch of the vehicle. It
will sound the horn if a door or the hood is opened, or if the key is turned in the ignition (the horn
option must be enabled and one of the door inputs must be connected).

• To arm the OEM-style alarm, press the

LOCK

button on the transmitter.

- The OEM-style alarm will ONLY arm if the

LOCK

button on the transmitter is pressed.

- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now

armed.

• To disarm the OEM-style alarm, press the

UNLOCK

button on the transmitter.

- To stop the horn from sounding if the OEM-style alarm is triggered, press the

LOCK

UNLOCK

button, or put the system in and out of Valet Mode.

Ready Mode Option

If the vehicle has a manual transmission, please read the following indications. In order to start
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected. Therefore, you must follow the appropriate procedure between
the two described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the

IGNITION ON (RUN)

position.