Autostart AS-2775 - Manual (Page 17)

Installation Guide P. 17
2. Before the lights go out, press and hold the brake pedal and then press one of the following
buttons:
LOCK ............................... to access menu 1;
UNLOCK ........................... to access menu 2;
TRUNK …………………… to access menu 3; or
START ............................. to access menu 4.
3. The parking lights will flash and the horn will honk (if programmed) once, twice, three or four
times to confirm entry into a menu.
4. Release the brake pedal.
Once the desired menu has been selected, the unit will fall (by default) into feature #1 of that
menu; you can now select the option you want in feature 1. Once this option has been chosen, the
unit will move on to feature 2 of the menu selected, and so on.
LOCK for Option 1,
UNLOCK for Option 2,
TRUNK for Option 3;
START for Option 4.
Programming Options
MENU 1 * INDICATES DEFAULT SETTING
FEATURE 1 – Ignition-controlled door locks
OPTION 1* Ignition lock DISABLED
OPTION 2 Ignition lock ENABLED
OPTION 3 Ignition unlock only
OPTION 4 Ignition lock only
FEATURE 2 – Secure Lock
OPTION 1* Secure lock DISABLED
OPTION 2 Standard secure lock ENABLED
OPTION 3 Smart secure lock ENABLED
FEATURE 3 – Starter Kill arming mode
OPTION 1* Passive arming (60 sec.)
OPTION 2 Active arming
OPTION 3 Passive arming (3 min.)
FEATURE 4 – Door lock / unlock pulse timing
OPTION 1* 7/10-sec. lock/unlock pulses
OPTION 2 4-sec. lock/unlock pulses
OPTION 3 7/10-sec. lock pulse and two ¼-sec. unlock pulses
OPTION 4 1/10-sec. lock/unlock pulses
FEATURE 5 – LED flashing
OPTION 1* ENABLED (without starter kill Æ will flash only when ignition is OFF )
OPTION 2 DISABLED
OPTION 3 ENABLED (with starter kill Æ will ONLY flash when the starter kill engages.
This option should be selected ONLY if the starter kill is installed.)
MENU 2 * INDICATES DEFAULT SETTING
FEATURE 1 – Safe Start
OPTION 1 Safe Start ENABLED
OPTION 2* Safe Start DISABLED
OPTION 3 “Swap Start” – enhanced safe start mode with extended safety: To start the engine: press
the LOCK and UNLOCK buttons simultaneously. To trigger AUX 2 : press START button.
FEATURE 2 – Engine Run Time
OPTION 1 Run Time = 3 minutes in gas mode / 8 minutes diesel mode
OPTION 2* Run Time = 15 minutes in gas mode / 20 minutes diesel mode
OPTION 3 Run Time = 25 minutes in gas mode / 30 minutes diesel mode
FEATURE 3 – Idle Mode & Turbo Mode (auto) / Turbo Mode (manual)
OPTION 1 Idle mode & turbo mode DISABLED (AUTO) / turbo mode DISABLED (MANUAL)
OPTION 2* Idle mode & turbo mode ENABLED (AUTO) / turbo mode DISABLED (MANUAL)
OPTION 3 Idle mode & turbo mode ENABLED (AUTO) / turbo mode ENABLED (MANUAL)
FEATURE 4 – Engine type and Cold Weather Mode
OPTION 1 Diesel mode with 20-minute run time in cold weather mode (30-sec. wait to start delay)
OPTION 2* Gas mode with 3-minute run time in cold weather mode
OPTION 3 Diesel mode with 8-minute run time in cold weather mode (18-sec. wait to start delay)
OPTION 4 Diesel mode with 8-minute run time in cold weather mode (7-sec. wait to start delay)
FEATURE 5 – Ignition Valet
OPTION 1 Ignition valet DISABLED