Sunex Tools SX545B - Manual (Page 2)

SX545B 2 Rev. 05/19/03
▲
WARNING!
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
!
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION MANUAL CAREFULLY
AND UNDERSTAND ALL INFORMATION BEFORE
OPERATING THIS TOOL.
• Always operate, inspect and maintain this tool in
accordance with American National Standards
Institute Safety Code of Portable Air Tools (ANSI
B186.1) and any other applicable safety codes
and regulations.
• For safety, top performance and maximum
durability of parts, operate this tool at 90 psig/
6.2 bar max air pressure with 3/8" diameter air
supply hose.
• Always wear impact-resistant eye and face
protection when operating or performing
maintenance on this tool.
• High sound levels can cause permanent hearing
loss. Always wear hearing protection when using
this tool.Use hearing protection as recommended
by your employer or OSHA regulation.
• Keep the tool in efficient operating condition.
• Operators and maintenance personnel must be
physically able to handle the bulk, weight and
power of this tool.
• Air under pressure can cause severe injury.
Never direct air at yourself or others. Always
turn off the air supply, drain hose of air pressure
and detach tool from air supply before installing,
removing or adjusting any accessory on this tool,
or before performing any maintenance on this
tool. Failure to do so could result in injury. Whip
hoses can cause serious injury. Always check for
damaged, frayed or loose hoses and fittings, and
replace immediately. Do not use quick detach
couplings at tool. See instructions for correct set-up.
• Air powered tools can vibrate in use.
Vibration, repetitive motions or uncomfortable
positions over extended periods of time may be
harmful to your hands and arms. Discontinue
use of tool if discomfort, tingling feeling or pain
occurs. Seek medical advice before resuming use.
• Place the tool on the work before starting
the tool.
• Slipping, tripping and/or falling while
operating air tools can be a major cause of
serious injury or death. Be aware of excess
hose left on the walking or work surface.
• Keep body working stance balanced and firm.
Do not overreach when operating the tool.
• Anticipate and be alert for sudden changes in
motion during start up and operation of any
power tool.
• Do not carry tool by the hose. Protect the hose
from sharp objects and heat.
• Tool shaft may continue to rotate briefly after
throttle is released. Avoid direct contact with
accessories during and after use. Gloves will
reduce the risk of cuts or burns.
• Keep away from rotating end of tool. Do not
wear jewelry or loose clothing. Secure long
hair. Scalping can occur if hair is not kept
away from tool and accessories. Choking can
occur if neckwear is not kept away from tool
and accessories.
• Drill bits can bind suddenly and cause rotation
of the work piece or tool, causing injury to
arms and/or shoulders. Enough torque is
generated to cause falls. Always use sharp
bits. Use less downward pressure at
breakthrough.
• Do not lubricate tools with flammable or
volatile liquids such as kerosene, diesel or
jet fuel.
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace any
damaged labels.
SX-545Bman_051903 5/19/03 4:44 PM Page 2