Sunex Tools SX4360-6 - Manual (Page 3)

Instruction Manual
This product is designed to tighten or loosen threaded
fasteners. No other use is permitted.
Air Supply Requirements
Tool is designed to operate at 90 psi (6.3 bar) at free speed
measured at the tool, of clean, dry air. Operating this tool at
higher pressures will drastically reduce the tool life and could
cause injury.
The air inlet thread on this tool is a standard 1/2" NPT.
Line pressure should be increased for any unusually long
air hose run (over 25 feet). Minimum hose diameter should
be 1/2" I.D. and all fittings should have the same inside
diameter. See diagram below for proper air supply setup.
Lubrication
Lubricate the tool each day after use with quality SAE #10
air motor oil. Add the oil to the air inlet or into the hose at the
nearest connection to the air supply then run the tool until
all excess oil is expelled from the exhaust. Total oil quantity
needed for this procedure is approximately 1 ounce.
Operation
This tool is an impacting tool and not a torque meter.
When specific torque is required, it must be checked with
a torque meter after fitting the fastener with the Impact.
If a nut does not move within five seconds, use a larger size
Impact. Do not use Impact Wrench beyond rated capacity, as
this can drastically reduce the tool life.
EC DECLARATION OF CONFORMITY
We, Sunex International Inc., 315 Hawkins Rd, Travelers Rest,
SC 29690, declare under our sole responsibility that the
product to which this declaration relates, is in conformity with
the requirements of the Council Directive of June 1998 on the
approximation of the laws of the Member States relating to
machinery. (EN792, 98/37/EC)
Harmonized Standards Applied:
EN 792-6
National Standards Applied:
ISO 8662-7, ISO 15744-2002
Machine Name:
SX4360-6 Impact Wrench
Serial No.:
MS0012010 or higher
Techical Data:
1" Sq. Dr. Std.
Air Pressure: 90 psi (6.2 bar)
Noise and Vibration Declaration
Tool produces a noise level (no load) of 86 dBA sound pressure
with 3 dBA uncertainty per EN ISO15744-2002. Vibration level
is 12.5 m/s2 tested per EN 28662-1 & EN28662-7:1997
Signature of Issuer:
Name and Position of Issuer: John Stratton, Product Manager
Sunex International Inc.
Date of Issue: January 17, 2012
Drain Daily
Regulator Oiler Quick Coupler Leader
Hose
Nipple
Do Not Install
Quick Coupling
Here
Nipple
Filter
Air Supply
Whip Hose
Specifications
Square Drive Size ..............................................1" (25.4mm)
Max. Torque ...................................1,600 Ft. Lbs. (2,169 Nm)
Working Torque ...............200-1,300 Ft. Lbs. (271-1,763 Nm)
Free Speed .......................................................... 6,000 RPM
Length .........................................................18.38" (467mm)
Weight ....................................................... 15.9 Lbs. (7.2 kg)
Avg. Air. Cons. ...........................................10 cfm (283 l/min)
Air Inlet ................................................................... 1/2" NPT
Min. Hose Size ............................................ 1/2" I.D. (13mm)
SX4360-6: Parts Breakdown & Operating Manual 3 02/03/12
SX4360-6_Manual_020312.indd 3 2/3/12 3:10 PM