AeroComm TRANSCEIVER ZB2430 - Manual (Page 37)

C O N F I G U R I N G T H E Z B 2 4 3 0 3 2
R ea d D e st i n at i o n Ad d r es s
The OEM Host issues this command to the transceiver to read the
Destination Address. Command: <0xCC> <0x11>
Number of bytes returned: 4
Response: <0xCC> <0x00>
Parameter Range:
= MSB of destination radio’s NWK address
= LSB of destination radio’s NWK address
A ut o D es t i na t i o n
The Host issues this command to change the Auto Destination
setting. When issuing this command, the Auto Destination setting
will only be changed if the corresponding enable bit is set.
Otherwise, the command performs a read of Auto Destination. Command: <0xCC> <0x15>
Number of Bytes Returned: 2
Response: <0xCC>
Parameter Range:
= bit 7: Ignored
bit 6: Ignored
bit 5: Ignored
bit 4: Read=0, Write =1
bit 3: Ignored
bit 2: Ignored
bit 1: Ignored
bit 0: Auto Destination
R ea d A P I Co n t r o l
The OEM Host issues this command to read the API Control byte. Command: <0xCC> <0x16>
Number of Bytes Returned: 2
Response: <0xCC>
Parameter Range:
= bits 7-3: 0
bit-2: Send Data Complete
bit-1: Transmit API
bit-0: Receive API
W ri t e A PI Co n t r o l
The OEM Host issues this command to write the API Control byte to
enable or disable the API features. Command: <0xCC> <0x17>
Number of Bytes Returned: 2
Response: <0xCC>
Parameter Range:
= bits 7-3: Ignored
bit-2: Send Data Complete
bit-1: Transmit API
bit-0: Receive API