Staub Electronics WPS-750-BUL-AH WIREPATH - SURVEILLANCE 750-SERIES BULLET ANALOG OUTDOOR CAMERA WITH IR AND HEATER (650TVL) - Manual (Page 7)

7
WPS-750-BUL-AH Installation Manual
© 2013 Wirepath Surveillance
1. Prepare Camera for Mounting
Prior to mounting to the Camera, we recommend that the position and
angles be preset in order to speed installation. These settings can be fine-
tuned once the Camera is mounted.
A. Adjust Camera Rotation
B. Adjust Swivel of Camera
C. Adjust Camera Angle
2. Connect the Camera to the System
Recommended Cabling:
- Video RG59 or RG6
- RS485 OSD Control Cat5e/6
- Power 18/2 or Cat5e/6
Important Note! Be sure to use the correct power supply
and power wire for the length of run to the camera to
ensure reliable operation. Too small a power supply or
wire will cause too much voltage drop, which will cause
the camera to operate incorrectly or not power up at all.
A
B
C
12V DC
Power In
BNC
Video Out
RS485 Leads
A. Connect the BNC video output to
the video in of a DVR or monitor.
B. Connect the DC Power In to a
12V DC-24V AC 1A power supply
using the included WPS-ACC-PWR
power adapter. The power supply
can be located at the head end
of system using a WPS-PS multiple
output power supply and prewiring a
power wire.
INSTALLATION INSTRUCTIONS