LevelOne PLI-3410 - Manual (Page 62)

62
default settings when you click on Apply button.
Note: When there is no QoS policy on the device, a warming message will pop-up as below
after clicking Apply.
QoS example:
The above illustration is an example for QoS topology, commonly in the home and small office
environment.
To set the QoS policy, perform the following steps:
1. Select Power Line Settings > QoS. In the Power Line QoS Settings screen, add new policy for
QoS.
2.
Run the “Command Prompt” (From the Windows desktop click Start > Run, type cmd and click
OK.). At the command prompt, type ipconfig /all and press Enter. Look for the line Physical
Address.