Emc statements ‐ fcc part 15 notice, Ices‐003, Declaration of conformity request – JuiceGoose NXRT Series User Manual
Page 3: Caution, Warning
NXRT‐1000, NXRT‐1500, NXRT‐2000, NXRT‐3000 USER’S MANUALUNINTERRUPTIBLE POWER SUPPLY (UPS)
EMC Statements ‐ FCC Part 15
Notice:
Pursuant to section 15 of the FCC rules, this product has been tested and thereby complies
to the conditions of a Class B (NXRT‐1000, NXRT‐1500) and Class A (NXRT‐2000, NXRT‐3000) digital
device, which have been established for offering sufficient protection against dangerous interference for
installation in a residential area. Installation and use of the equipment should comply with the
instructions provided in order to avoid such interference due to the amount of radio frequency energy
that is radiated and generated by the equipment. In spite of this, we cannot assure that a certain
amount of interference may not occur in some installations. If, by turning on and off, it can be deduced
that your radio or television reception is found to be influenced by harmful interference from the
equipment, it is recommended to use one of the following preventive measures.
• Place the receiving antenna in a separate location or orientation.
• Ensure a greater distance is achieved between the receiver and the equipment.
• Ensure that your equipment is connected to an outlet on a separate circuit than the
receiver.
• Contact a technician experienced with radio and TV or a dealer for further assistance.
ICES‐003
This Class B Interference Causing Equipment meets all requirements of the Canadian Interference
Causing Equipment Regulations ICES‐003. Cet appareil numerique de la classe B respecte toutes les
exigencies du Reglement sur le materiel brouilleur du Canada.
Declaration of Conformity Request
Units labeled with a UL mark comply with the following standards and directives:
• UL 1778
CAUTION:
A shielded‐type power cord is required in order to meet FCC emission limits and to
prevent interference to the nearby radio or TV reception. It is essential that only the supplied power
cord be used. Use only shielded cables to connect I/O devices to this equipment.
WARNING:
Any changes or modifications not expressly approved by the manufacturer of this
device could void the user’s authority to operate the equipment.
[3]