JuiceGoose NXRT Series - Manual (Page 24)

NXRT‐1000, NXRT‐1500, NXRT‐2000, NXRT‐3000 USER’S MANUALUNINTERRUPTIBLE POWER SUPPLY (UPS)
• NOTE: PLEASE VERIFY AUTOMATIC SHUTDOWN TIME PARAMETERS IN THE
SETTINGS SECTION FOR YOUR SPECIFIC INSTALLATION.
9. After charging is complete, connect the loads to the UPS while monitoring the load levels
via the UPS LCD or via the software.
• Do not connect any devices that have the possibility of overloading the UPS.
Refer to the Troubleshooting section and/or Technical Support with any problems during setup.
USER’S OPERATIONS
The only operations that users are permitted to do are:
• Turning the UPS unit ON or OFF
• Operating the user interfaces
• Connecting data interface cables
• Changing the batteries
All such operations are to be performed exactly as instructed in this manual. The greatest care possible
must be taken for any of these operations, and any change thereof may prove very hazardous to the
operator.
On/Off Button Function Button Inquiry Button
Turning Off the UPS when connected to an AC source
• Press and hold the ON/OFF button for more than 3 seconds to turn off the UPS. This means the
internal inverter has been deactivated.
• The unit will run a self test prior to the deactivation of the inverter.
• The green LED will be off and the yellow LED will be on. The LCD display will indicate “On BPS”,
which means the UPS in providing no output.
Starting the UPS from a DC source (cold start)
• Assure that the UPS has fully charged batteries and the internal battery pack is connected.
• Assure that there is no AC input power source and/or the unit is not plugged into an outlet.
• Press and hold the ON/OFF button for three seconds.
[24]