HTP PHE199-119 - Manual (Page 9)

9
LP-314 REV. 3.24.14
C. OPTIONAL EQUIPMENT
Below is a list of optional equipment available from HTP:
 3” Stainless Steel Outside Termination Vent Kit (V1000)
 4” Stainless Steel Outside Termination Vent Kit (V2000)
 2” PVC Concentric Vent Kit (Part # KGAVT0501CVT)

3" PVC Concentric Vent Kit (Part # KGAVT0601CVT)
 3” Polypro Vent Kit (Part # 8400P-001)
 3” Polypro Pipe (33’ length Part # 8400P-002, 49.5’ length Part # 8400P-003)

System Sensor (Part # 7250P-324)

Alarm System (Part # 7350P-602) to monitor any failure

PC Connection Kit (Part # 7250P-320)

Condensate Neutralizer (Part # 7450P-212)

Outdoor Sensor (Part # 7250P-319)

Versa-Hydro Solar Kit (Part # 7100P-220)
NOTE: When using an optional system sensor, pipe insulation must be wrapped around it to improve temperature measurement
accuracy and increase overall system efficiency.
PART 3 – PREPARE APPLIANCE LOCATION
Carefully consider installation when determining appliance location. Please read the entire manual before attempting installation.
Failure to properly take factors such as appliance venting, piping, condensate removal, and wiring into account before installation could
result in wasted time, money, and possible property damage and personal injury.
A. BEFORE LOCATING THE APPLIANCE
Incorrect ambient conditions can lead to damage to the heating system and put safe operation at risk. Ensure that the appliance
installation location adheres to the information included in this manual. Failure to do so could result in property damage, serious
personal injury, or death.
Failure of appliance or components due to incorrect operating conditions IS NOT covered by product warranty.
1. Installation Area (Mechanical Room) Operating Conditions

Ensure ambient temperatures are higher than 32
o
F/0
o
C and lower than 104
o
F/40
o
C.

Prevent the air from becoming contaminated by the products, places, and conditions listed in this manual, Part 3, Section F.

Avoid continuously high levels of humidity

Never close existing ventilation openings
 Ensure a minimum 1” clearance around hot water and exhaust vent pipes
The service life of the appliance ’s exposed metallic surfaces, such as the casing, as well as internal surfaces, such as the heat
exchanger, are directly influenced by proximity to damp and salty marine environments. In such areas, higher concentration levels of
chlorides from sea spray coupled with relative humidity can lead to degradation of the heat exchanger and other appliance components.
In these environments, appliances must not be installed using direct vent systems which draw outdoor air for combustion. Such
appliances must be installed using room air for combustion. Indoor air will have a much lower relative humidity and, hence, potential
corrosion will be minimized.