HTP PHE199-119 - Manual (Page 10)

10
LP-314 REV. 3.24.14
This appliance is certified for indoor installations only. Do not install the appliance outdoors. Failure to install this appliance indoors
could result in substantial property damage, severe personal injury, or death.
2. Check for nearby connections to:

System water piping

Venting connections

Gas supply piping

Electrical power

Condensate drain
3. Check area around appliance. Remove any combustible materials, gasoline, and other flammable liquids.
Failure to keep appliance area clear and free of combustible materials, liquids, and vapors can result in substantial property damage,
severe personal injury, or death.
4. Gas control system components must be protected from dripping water during operation and service.
5. If the appliance is to replace an existing appliance, check for and correct any existing system problems, such as:

System leaks

Location that could cause the system and appliance to freeze and leak.

Incorrectly-sized expansion tank
6. Clean and flush system when reinstalling an appliance.
NOTE: When installing in a zero clearance location, it may not be possible to read or view some product labeling. It is recommended to
make note of the appliance model and serial number.
B. LEVELING
In order for the condensate to properly flow out of the collection system, the area where you locate the appliance must be level.
Location must also fully support the weight of the filled appliance.
C. CLEARANCES FOR SERVICE ACCESS
Figure 1 - If you do not provide the minimum clearances shown above, it might not be possible to service the appliance
without removing it from the space.
A catch pan must be installed to protect the surrounding area from possible leaking water damage.