Sonnet Technologies 3Gb_s RAID Controller Card - Manual (Page 2)

Software Installation Steps
Mac OS X Driver and Software Installation
This section describes the installation of drivers and software to
support the Sonnet RAID controller in systems running Mac OS
X Version 10.4 and later.
1. Insert the Sonnet RAID Controller Installer CD into the CD-
ROM drive. Double-click the Sonnet RAID CD icon. When
the Sonnet RAID x.xx window appears, double-click the
Drivers folder.
2. Double-click the ATTOExpressSASRAID_xxx.pkg icon to
launch the installer (xxx is the version).
3. When the Welcome to the ATTO ExpressSAS RAID Driver
Installer window appears, click Continue.
4. When the Software License Agreement window appears, read
the agreement, click Continue, and then click Agree.
5. When the Installation Type window appears, accept the
default location or choose a different one, and then click
Install.
6. When the Easy Install window appears, click Install.
7. When the Authenticate window appears, enter the
Administrator password, and then click OK.
8. When the Summary window appears, click Restart to restart
your system and finish the driver installation.
9. If necessary, double-click the Sonnet RAID CD icon. In the
Sonnet RAID x.xx window, double-click the Configuration
Tool folder.
10. Double-click the ConfigTool icon to launch the
Configuration Tool installer.
11. When the Authenticate window appears, enter the
Administrator password, and then click OK.
12. When the Introduction window appears, click Next.
13. When the License Agreement window appears, read the
agreement, click the I accept the terms of the License
Agreement radio button, and then click Next.
14. When the Choose Install Folder window appears, accept the
default location or choose a different one, and then click
Next.
15. When the Choose Install Set window appears, click the icon
next to Full Installation, and then click Next.
16. When the Pre-Installation Summary window appears, click
Install.
17. When the Install Complete window appears, click Done to
quit the installer.
18. Shut down your computer, and proceed to Hardware
Installation on page 6.