Sonnet Technologies Tempo RAID66 ATA Hardware RAID Controller Card - Manual (Page 4)

4
Installation Steps – Striping Configuration (continued)
Tempo RAID66 Macintosh
ATA Hardware RAID Controller
striping
mode
Figure 8
Figure 9
Figure 10
15. Shut down the computer.
16. Move DIP switch 2 to ON to select the striping mode (Figure 8).
17. If you removed the card to move the DIP switches, verify the card is seated
firmly in the slot.
18. Recheck the cable connections; make sure all cables are properly connected
to the Tempo RAID66 and the hard drives.
19. Close the computer and carefully replace its case cover; be very careful not to
crimp the cables.
20. Turn on your computer.
21. Open Drive Setup again. You will see instead of
for each volume (pair of hard drives) connected to the
Tempo RAID66; you must now initialize each of the unmounted volumes
(Figure 9).
22. Name each of the volumes once they have been initialized; each pair of hard
drives (a volume) will appear on the desktop as a single “virtual” drive
(Figure 10). Your drives are now ready for use.
Support Note: The Tempo RAID66 creates one striped volume for each
pair of hard drives installed – one pair of drives creates one volume, two
pairs of drives create two volumes.