SKC 224-PCXR4 Universal Pump - Manual (Page 22)

20
Parts Descriptions
Use only SKC-approved parts to ensure reliable performance. Failure to do so
voids any warranty and UL Listing for intrinsic safety.
See page 21 for drawing.
No. Description
1 LCD indicates all sampler functions.
2 FLOW AND BATTERY CHECK Key allows fl ow rate setting and battery condition testing.
3 START/HOLD Key is used to start the sampling cycle, pause the sampling cycle, and
restart the cycle after pause.
4 ON/OFF Switch shuts down the pump completely and clears time display.
5 Tamper-resistant Cover protects controls from incidental contact or tampering.
6 Cover Screw fastens tamper-resistant cover.
7 Flow Adjustment Control adjusts fl ow from 1000 to 5000 ml/min.
8 Accessory Mounting Screws (2) secure accessories such as impinger and trap holders.
9 Intake/Filter Housing air intake port and trap
10 Filter Housing Screws (4) secure fi lter housing
11 Filter O-ring - leak seal for fi lter in housing
12 Filter (crimped fi ber polyester) prevents particles from entering pump.
13 Built-in Flowmeter monitors fl ow changes.
14 Cap Screw accesses regulator.
15 Cap Screw accesses air discharge port.
16 Battery Pack Screws (2) secure pack to pump.
17 Battery Pack Assembly provides power to pump.
18 Charging Jack, connector for battery charger
19 Belt Clip secures pump to worker.
A Compensation Pot A adjusts pump compensation, which is factory set. Access screw
guards against accidental contact or tampering.
B Compensation Pot B adjusts pump compensation, which is factory set. Access screw
guards against accidental contact or tampering.