Installing the battery pack, Replacing the battery pack – SKC 224-PCXR4 Universal Pump User Manual
Page 20
18
Installing the Battery Pack
To enhance battery life, SKC ships battery packs separate from the
pump. Once installed, completely charge battery pack before operating
pump.
1. Loosen the two case screws above and below the belt clip.
2. Slip the front edge of the battery pack under the belt clip and posi-
tion battery pack to engage the grooves in the case.
3. Slide battery pack toward the pump until it is fl ush with the pump
case on all sides.
4. Install two battery screws and tighten the case screws loosened in
Step 1.
5. Charge battery completely. For optimum charge, ensure pump is not
running during charging.
Replacing the Battery Pack
To enhance battery life, SKC ships battery packs separate from
the pump. Once installed, completely charge battery pack before
operating pump.
1. Remove the two screws that secure the battery pack and loosen the
two case screws above and below the belt clip.
2. Carefully slide battery pack out from under the belt clip. Ensure that
the battery is kept level.
3. Slip the front edge of the new battery pack under the belt clip and
position battery pack to engage the grooves in the case.
4. Slide the battery pack toward the pump until it is fl ush with the
pump case on all sides.
5. Reinstall battery screws and tighten the case screws.
Back of pump
with battery
pack sliding out
Beltclip
Case screw
(not shown)
Batt ery pack screws
Case screw
Case grooves
Batt ery connector
Important Cautions/Warnings on next page