SecurityMan ClockCamDVR - Manual (Page 20)

12
To operate the ClockCamDVR use the remote control, press the REC button to start
manual video recording and press the STOP button to stop manual recording (remote
control only).
In manual recording mode, the DVR system will continuously record until the
STOP button
is pressed or the system will stop once the Micro SD capacity is full given the Overwrite
option is set to OFF. A new file will automatically be generated when the recorded file
reaches 15 minutes of recording. The DVR will continue to recreate and generate 15
minutes files, non-stop, if the Overwrite option is turned ON.
Press the
TRIGGER ON button to initiate motion detection recording based on movement
or motion and press the TRIGGER OFF button turn off motion detection recording. Motion
detection can also be turn ON or OFF by pressing on the DETECT button located at the
back side of the wall clock camera. Press on the DETECT button once to initiate motion
detection recording based on movement or motion and press the DETECT button again
to stop motion detection recording as illustrated below.
In MD (motion detection) mode, the DVR system has a 3 seconds pre-alarm recording
feature. Which means before the alarm trigger and start to record the 15 seconds motion
detection record time, there is a pre 3 seconds recording of the event prior to the start of
the 15 seconds recording, totaling 18 seconds. When detected object(s) is constantly