AMX Wall Docking Station MVP-WDS User Manual
Page 26
MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
20
MVP-WDS Wall Docking Station for MVP Panels
7.
Disconnect the 2-pin mini-Phoenix connector from the side of the docking station to remove power
from the unit and maintain the support cradle in this angled position.
8.
Close the battery cover.
9.
Remove the two #6-32 Faceplate Security Screws from the top rim of the faceplate (FIG. 20) and
place these aside.
10.
Position the MVP-WDS unit so the Security Release pushbutton is positioned directly in front of
you, then grasp the top rim of the faceplate and begin to angle it upwards. At this point, the faceplate
is still connected to the Security Latch (located behind the securing magnet, as shown in FIG. 20).
11.
Hold down the unit with both hands and (in one motion), pull the top rim of the faceplate directly
towards you and then over the Security Latch to allow it to be removed from the main unit.
12.
Grab the bottom rim of the faceplate and place your thumbs just below either side of the Security
Release Pushbutton.
13.
In one single motion, use your thumbs to push the bottom rim towards the cradle, and then pull it
upwards to slide the four faceplate connectors up and away from their respective securing latches
along the bottom of the MVP-WDS (FIG. 21).
FIG. 19
Cradle activation pushbutton location and cradle angling
FIG. 20
Faceplate screw removal
Battery Compartment Cover
Battery Compartment Latch
Cradle
MVP Support
Activation
pushbutton
Power supply feed
(located inside
Battery Slot #2)
Cradle
Die Cut Foam
Cover location
(2-pin 3.5 mm mini-Phoenix)
Faceplate
MVP Support Cradle
#6-32 Faceplate
Security Latch
Security Screws
Security Release pushbutton