AMX Wall Docking Station MVP-WDS - Manual (Page 15)

MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
9 MVP-WDS Wall Docking Station for MVP Panels
3. Using a grounded Phillips-head screwdriver, insert and secure four #6-32 Mounting Screws (not
included) into their corresponding holes located along the sides of the MVP-WDS until the WDS is
securely fastened to the rough-in box, and is flush against the wall.
4. Follow the steps outlined in the Replacing the Faceplate on the MVP-WDS section on page 13 to re-
install the faceplate.
Installing the MVP-WDS Using Expansion Clips
Expansion clips are mounted through the four oval holes located along the rim of the MVP-WDS. As the
screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a
"grip" on the wall by either pressing onto the wall or by securing the drywall between the housing and
the drywall clip.
The faceplate must be removed prior to any surface installation (see the Removing the MVP-
WDS Faceplate section on page 5).
The outer frame Mounting Tabs must be flush against the mounting surface.
1. Cut out the surface for the WDS using the dimensions shown in installation diagram SP-5965-01
(reproduced in FIG. 11 on page 10). It is recommended that you cutout the surface slightly smaller
than what is outlined in the installation drawings so that you can make any necessary cutout
adjustments.
Be sure to cut out the four notches along the sides to accommodate the four drywall expansion clips
(included).
When installing the four #6-32 Mounting Screws in Step 3, turn the screwdriver gently
to engage the first one or two threads of the screw and make sure that the screw is
being driven straight through the holes in the Mounting Tab (FIG. 10).
If the screw is found to be entering the Mounting Tab an angle, back it out of
the hole immediately and try again to avoid damaging the MVP-WDS.
FIG. 10 Installing four #6-32 Mounting Screws in Step 3