beautypg.com

Rivers edge® spin shot – Rivers Edge RE637 Spin Shot User Manual

Page 7

background image

Check for parts online at

www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5

7

Operator's Manual

Rivers Edge® Spin Shot™

SWIVEL SEAT ASSEMBLY INSTRUCTIONS

NOTE: Swivel seat assembly must be assembled on the ground. Do

not attach to platform until ladder is uprighted, attached to tree

per Set-Up and Use Instructions and you are properly attached to

the tree with provided Full Body Harness per its instructions.

11. Attach swivel (48662) to either end of seat post (TP11) using (4)

provided 1/4-20 x 3/4” bolts and locknuts. SEE FIGURE 6

NOTE: Make sure head of bolts are on swivel side and nut on bottom

of seat post plate to prevent any obstruction when swivel is pivoted

during use.

12. Attach factory assembled seat (16857) to the swivel using (4)

provided 1/4-20 x 1-1/4” bolts and locknuts. SEE FIGURE 6

NOTE: Make sure head of bolts are on swivel side and nut on top

of seat frame to prevent any obstruction when swivel is pivoted

during use.

13. Attach factory assembled backrest (17630) to tabs of seat frame

using (2) provided 1/4-20 x 1-1/4” bolts and locknuts. SEE FIGUE 7

14. For assembly of the armrests, you must first remove the “front” factory

installed (2) bolts from assembled seat frame and the “bottom”
factory installed (2) bolts from assembled backrest frame. Discard
this hardware. SEE FIGURE 8

FIGURE 7

FIGURE 8

FIGURE 6

swivel

seat post

1/4-20- x 3/4"

bolt

locknut

locknut

1/4-20- x 1-1/4"

bolt

seat

backrest

1/4-20- x 1-1/4"

bolt

locknut

seat frame

tab

seat

factory installed

locknut

factory installed

"bottom" bolt

factory installed

"front" bolt

factory installed

locknut